Christie Roadie HD+35K Manual do Utilizador Página 32
- Página / 192
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
2-16 Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Section 2: Installation and Setup
Figure 2-17 Adjusting the Feet
2.3.4 Tilting and Special Orientations
Tilting
For any installation, you can tilt the front end of the
projector up or down as much as 15°.
Likewise, side-to-side tilt must not exceed 15° (see ).
This limit ensures safe lamp operation and proper
position of the liquid cooling reservoir in the projector.
Tilt only as shown in Figure 2-18
and
Figure 2-19.
± 15° max.± 15° max.
± 15° max.
Figure 2-18 Front End Tilt
- Roadie HD+35K 1
- NOTICES 4
- Table of Contents 5
- 1 Introduction 11
- 1.1.1 Labels and Marking 12
- 1.3 Projector Overview 13
- 1.3.2 List of Components 14
- 1.3.3 Key Features 14
- Section 1: Introduction 15
- Figure 1-1 15
- Figure 1-2 15
- 2 Installation and Setup 17
- Head to Ballast 18
- Ballast to AC 18
- Projector Rear 18
- Head-to-AC 19
- 200-240 VAC 20
- OWER for at least two seconds 21
- ENU on the 21
- 2.2.1 Screen Type 22
- Rear Screen Installations 23
- 16:9 screen 24
- 5:4 screen 24
- “Flat” Image “Scope” Image 25
- 1.85 image 26
- 2.39 image 26
- Masking moved aside 26
- SIDE-MASKING SCREEN 26
- 2.2.4 Ambient Lighting 27
- 2.2.5 Other Considerations 27
- 2.3.1 Throw Distance 28
- Vertical Position 29
- Adjusting the Feet 31
- ± 15° max.± 15° max 32
- ± 15° max 32
- Special Orientations 33
- Maintain 34
- TOP VIEW 35
- BOTTOM VIEW 35
- = rigging zone 35
- Using the FredFrame™ 36
- Using a Fork Lift 36
- Stacking 36
- Primary Lens 36
- 2.4.2 Install First Lamp 38
- Liquid Cooling 39
- NOTES: 1) 40
- 2) Use high quality shielded 40
- 2.5.1 RGB Signals 41
- A.k.a.: 42
- • Component 42
- • Y, R-Y, B-Y 42
- From Composite 43
- Video Source 43
- From S-Video 43
- 2.6 Connecting Communications 44
- for more information 45
- RS-232 Serial Communications 46
- RS-422 Serial Communications 46
- Side Input Panel 47
- Ethernet Communications 48
- The GPIO Port 48
- RS-232 Network 49
- RS-422 Network 49
- Ethernet Network Setup 50
- Use Ethernet cables to 51
- Changing the Port # 52
- ArtNet Interface Settings 52
- Communications menu 53
- Separate option is 53
- NOTE: Programming for the 54
- RS-232 controller must be 54
- 2.8 Connecting the Ballast 56
- 2.9 Initial Switch On 57
- 2.10 Maximizing Light Output 58
- 2.11 Basic Image Adjustment 58
- 2.12 Boresight Adjustment 59
- H Boresight 60
- V Boresight 61
- 2.13.2 Color Gamut Adjustment 62
- 2.13.3 Maximizing Brightness 62
- 2.13.4 DMD Convergence 62
- 2.13.5 Fold Mirror Adjustment 62
- Roadie 35K Standard IR Remote 64
- Shortcut Method 65
- 3.1 Projector Basics 67
- 3-2 Roadie HD+35K User Manual 68
- Zoom and Focus 69
- Lens Offset 69
- 3.1.9 Lamp 70
- 3.1.10 Leveling Feet 70
- 3.1.11 DC Power Cables 70
- 3.1.12 Projection Head 70
- 3.1.13 Rear Connection Panel 70
- Roadie HD+35K User Manual 3-5 71
- 3.1.14 Security Locks 72
- 3.2.1 Built-in Keypad 72
- Menu system 72
- 3.2.3 Wired IR Remote 73
- Laser functionality 74
- Power (ON/OFF) Key 75
- Test Function Key 75
- Auto (Setup) Function Key 75
- Table 3.3 Auto Setup 76
- Input 5 Key (OPT.1) 77
- Input 6 Key (OPT.2) 77
- Contrast Key 77
- Brightness Key 77
- Gamma Key 78
- Menu Key 78
- OSD (On-Screen Display) Key 78
- Shutter Key 78
- Function Key 79
- Projector Key 79
- Enter Key 79
- Exit Key 80
- Arrow Keys 80
- PIP (Picture-in-Picture) Key 80
- Backlighting Function 81
- 3.5.1 On-line Help 83
- Slidebars in Menus 84
- "Direct" Slidebars 84
- Check Boxes 85
- Drop-down Lists 85
- Activate the Edit Window 85
- Edit a Character 86
- Press Enter when Finished 86
- Using Auto Setup 87
- Resize Presets Option 88
- Default Option 89
- Full Size Option 90
- Size Option 91
- Vertical Stretch Option 91
- Pixel Track Option 91
- Pixel Phase Option 91
- H-Position Option 92
- V-Position Option 92
- Contrast Option 94
- Brightness Option 94
- Gamma Option 94
- Filter Option 94
- Detail Option 95
- Noise Reduction Option 95
- Color Space Option 95
- Video Options Secondary Menu 95
- (SUBJECT-TO-CHANGE) 96
- Input Levels Option Menu 97
- Input Levels menu 98
- Color Enable Control 98
- Advanced Image Settings 99
- Simulation 3D 100
- 3.7 Using Inputs and Channels 101
- Section 3: Operation 102
- Using a Channel 103
- Signal Types 105
- CHAN key on the remote or 107
- CHAN key on the remote 107
- Image Orientation 108
- Auto Power-up 108
- Set Date & Time 108
- Language 108
- Menu Preferences 109
- Baud Rates 110
- Projector 110
- Network Routing 110
- Separate 110
- DMX Channel Function Value 112
- Broadcast Key 113
- Backlight 113
- Front IR / Back IR 113
- Wired Keypad 114
- Test Pattern 114
- Keystone 114
- Edge Blending Secondary Menu 115
- Defining User Color Gamuts 116
- Test Pattern Grey Level 118
- Freeze Image 118
- Color Enable 118
- Odd Pixel Adjustment 118
- Lens Calibration 119
- 3.9 Working with PIP 120
- Swap Main and PIP Image 122
- PIP Enable 122
- PIP Border Width 123
- PIP Border Color 123
- Numbers Select Main Image 123
- Lamp Installed label 124
- 3.10.2 Lamp Cable Lengths 124
- Lamp OFF 125
- 3.10.5 Lamp Menu 126
- Not in lumens 127
- Lamp History menu 128
- Using the LampLOC™ Slidebars 129
- 3.10.7 Stand-by Mode 130
- 3.11 Status Menu 131
- Preliminary Calibration 132
- Color Adjustment Procedure 132
- Advanced Image Settings menu 134
- Before You Begin 135
- General Setup 135
- LIGHT OUTPUT in 8 Zones 137
- What is a Blend? 138
- How Are Blends Used? 138
- Flat Blends vs. Warped Blends 139
- Main Functions 139
- Other Functions 141
- Edge Blending Procedure 141
- Edge Blending (2) menu to 50 142
- 3.14 Working with the Lenses 143
- User Errors 144
- Invalid User Entry 144
- Input Signal Errors 144
- No Signal 144
- Bad Sync 145
- Other Signal Error Messages 145
- System Warnings 145
- System Errors 145
- The Status LED Codes 145
- Table 3.9 System Error Codes 146
- 4 Maintenance 149
- 4.1.3 Lamp Precautions 150
- 4.3 Maintenance and Cleaning 151
- 4-4 Roadie HD+35K User Manual 152
- 4.3.3 Other Components 153
- Section 4: Maintenance 154
- Figure 4-2 154
- Figure 4-1 Install Bulb 155
- 4-8 Roadie HD+35K User Manual 156
- 4.5 Replacing a Lens 158
- UP label on lens 159
- 5 Troubleshooting 161
- Section 5: Troubleshooting 162
- 5.4 Built In Keypad 163
- 5.5 Image Displays 163
- 6 Specifications 167
- 6.2 Lenses 168
- 6.3 Inputs 168
- 6.3.4 DVI-I (INPUT 2) 169
- 6.4 Control 170
- 6.5 Power 171
- 6.6 Lamps 172
- Roadie HD+35K User Manual 6-7 173
- 6.12.2 Weight & Size 174
- (Sold Separately) 175
- Projection Lenses 175
- A.1 Serial Links to Projector 177
- IMPORTANT 178
- Wiring: Extension cable 179
- Wiring: “Swap” cable 179
- A-4 Roadie HD+35K User Manual 180
- Appendix B: Menu Tree 181
- Appendix B - Menu Tree 183
- Appendix B - Menu Tree B-3 183
- 020-100340-02 Rev.1 (01-2010) 183
- B-4 Appendix B - Menu Tree 184
- Appendix B - Menu Tree B-5 185
- B-6 Appendix B - Menu Tree 186
- C.1 Introduction 187
- C.1.2 Query Command 188
- C.1.3 Real Time Event 188
- D.1 DVI Input Module 189
- D.2 Dual SD/HD-SDI Module 189
Manuais e produtos relacionados com Projetores Christie Roadie HD+35K
Projetores Christie X552S Manual do Utilizador
(241 páginas)
(241 páginas)
Projetores Christie DS+65 Manual do Utilizador
(135 páginas)
(135 páginas)
Projetores Christie 1920-DX Manual do Utilizador
(8 páginas)
(8 páginas)
Projetores Christie Matrix 3000 Manual do Utilizador
(21 páginas)
(21 páginas)
Projetores Christie J series 2.0kW Especificações
(15 páginas)
(15 páginas)
Projetores Christie Roadster Manual do Utilizador
(52 páginas)
(52 páginas)
Projetores Christie LX380L Manual do Utilizador
(128 páginas)
(128 páginas)
Projetores Christie DWX600-G Manual do Utilizador
(96 páginas)
(96 páginas)
Projetores Christie LW551i Manual do Utilizador
(74 páginas)
(74 páginas)
Projetores Christie CP2230 Manual do Utilizador
(68 páginas)
(68 páginas)
Projetores Christie DS4K Manual do Utilizador
(194 páginas)
(194 páginas)
Projetores Christie 1920-DX Manual do Utilizador
(12 páginas)
(12 páginas)
(46 páginas)
Projetores Christie CP2000-MR Manual do Utilizador
(82 páginas)
(82 páginas)
Projetores Christie M-Series Manual do Utilizador
(68 páginas)
(68 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.057 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais