Christie Roadie HD+35K Manual do Utilizador descarregar pdf (Página 159)

Section 4: Maintenance

Roadie HD+35K User Manual 4-11

020-100340-02 Rev. 1 (01-2010)

3. Pull out lens and replace as described in Section 2.4.1 Lens Installation. Insert all the way back, following

UP label on lens.

NOTE: Ensure that the Zoom connector is fully engaged.

In the event a lens is dropped, the lens tether and clamp assembly may become

stressed, and therefore must be replaced before continuing its use. Failure to do so

could result in injury or death.

Lens calibration must be performed each time a new lens is inserted or after

performing manual lens mount adjustments. This is critical to the projector

functioning properly. Failure to do so could result in damage to the lens mount, the

projector, or the projection lens.

Make sure to secure with lens locking lever (UP position) and safety tether: Refer to Figure 2-23.

NOTES: 1) Make sure the lens UP label faces up, otherwise boresight may need readjustment. 2) Keep the lens

safety tether attached to the projector ‘s handle or FredFrame™ for use with any lens ring clamp. This

cable MUST be used with a flown projector.

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 191 192

Sem comentários

Christie Roadie HD+35K Manual do Utilizador Página 159