Christie Roadie HD+35K Manual do Utilizador descarregar pdf (Página 103)

Section 3: Operation

Roadie HD+35K User Manual 3-37

020-100340-02 Rev. 1 (01-2010)

Figure 3-19 Channel List

Shown above is a sample list of channels available when you press the CHAN key. This is typically called the

“

Channel list”.

NOTE: The CHAN key may display a channel list or not, depending on what you have defined for "Display

Channel List" (refer to

Menu Preferences later in this section).

In order to access channels by using the CHAN key on the remote, you must first create the channels. See

below.

3.7.2 Creating a New Channel

To use a new input source with the projector, a new channel must be added to the projector memory so that the

projector responds properly to an input signal from that source in the future. A new channel can be created

automatically, as described here, or it can be copied from an existing channel, and then edited as necessary (see

Section 3.7.5 Copying a Channel

later in this section).

When you select a direct input (Input 1, Input 2, Input 3, Input 4, Input 5, or Input 6), any existing channels

in the projector are searched for matching input and signal parameters. If no match to the incoming input signal

is found in currently-defined channels, a new channel is temporarily created based on factory-defined defaults

for this type of signal. The channel number assigned is the lowest available number from 01-99.

NOTES: 1) An automatic channel is discarded unless one or more of its parameters are changed, and it does not

appear in the channel list (see below).

2) If two channels have the same distinguishing source

characteristics except for the reversal of sync connectors (i.e., H-sync and V-sync, are switched), they are

still defined as distinct channels.

3) You cannot define a new channel without an incoming signal.

If the incoming signal does match an existing channel, the image is set up and displays as usual, according to

the parameters currently defined for that channel.

3.7.3 Selecting a Channel

Using a Channel

You can normally select a channel at any time by pressing CHAN. If you want to prevent a channel from

appearing in this list, you must edit the channel as described in Section 3.7.7 Editing a Channel Setup

later in

this section. Such a channel can still be selected by entering its number as shown below.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 191 192

Sem comentários

Christie Roadie HD+35K Manual do Utilizador Página 103