Christie Mirage WQ-L Manual do Utilizador descarregar pdf (Página 22)

Installation

Mirage WQ-L User Manual 22

020-101372-02 Rev. 1 (10-2014)

5. If the controller is connected via an Ethernet cable, set the IP address from the WebUI in

Configuration > Communications > Ethernet Settings.

6. Set the serial options in Configuration > Communications.

7. From the WebUI, select Configuration > Communications > Network Routing.

• To relay commands to all projectors set Network Routing to All Joined.

• To isolate RS422 communications, select RS232 and Ethernet Joined. Only projector

#3 will respond to the RS422 controller.

• To isolate Ethernet communications, select RS232 and RS422 Joined. Only projector

#1 will respond using Ethernet

RS232 Network

In an RS232 network the controller can communicate with the first projector and the command can

be relayed to each serially connected projector.

1. Connect the controller to one projector by connecting a serial cable between the PC and the

RS232 IN port on the input panel.

2. Connect a serial cable between the RS232 OUT connector of the first projector and the RS232

IN connector of the next projector.

3. Connect the remaining projectors.

4. Set the RS232 serial options in Configuration > Communications > Serial (RS232 IN)

Options.

Using the wrong type of serial cable can damage the projector. RS232 communication cables

must be of good quality and no more than 25 ft (7.62 m) in length. Failure to comply may

result in equipment damage.

Ethernet Hub

Projector #1

Projector #2

Projector #3

RS422

CAT5

RS232 RS232

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 79 80

Sem comentários

Christie Mirage WQ-L Manual do Utilizador Página 22