Christie CC70 Manual do Operador descarregar pdf (Página 17)

4: Installation Procedures

CHRISTIE INCORPORATED 4-5

February, 1999

4.2.4. MOUNTING THE PROJECTOR

The SLC Console includes a standard projector mounting bracket for CHRISTIE P35

projectors. If any other model projector is to be mounted, contact the CHRISTIE factory.

1. Mount projector on projector mounting bracket (Item 13 in Figure A-2).

2. Ensure that projector is level and in line with console before tightening mounting bolts.

3. Verify that all four (4) bolts are installed and securely tightened.

4.3. ELECTRICAL CONNECTIONS

SLC Consoles are factory wired and tested. All functions have been carefully tested and

calibrated to prevent problems during installation and operation.

WARNING

Before connecting, pull AC disconnect switch in all AC supply lines.

4.3.1. VERIFY VOLTAGE

Check the AC voltage shown on the console nameplates. Then measure the AC supply

voltages with a voltmeter. Verify that the measured voltages do not differ by more than 10%

from the rated nominal values of the unit.

4.3.2. WIRING HOOK-UP

1. Pull 3-phase wires and single-phase and ground wires through one of knock-out holes

located on front of non-operating side on foot of console. Check charts in Figure 4-4 and

Figure 4-5 for correct wire size.

WARNING

Grounding wire (green) must be at least as large in diameter as largest

wire used for AC power connections.

2. Connect 3-phase wires to Terminal Board TB2–L1, TB2–L2, and TB2–L3.

3. Connect single-phase wires to TB2–L1, Neutral, marked 115V single-phase. Connect

ground wire to TB2–ground.

4. Check Schematic and/or Automation Manual for wiring hook-up to TB5. These

connections are for projector, sound, changeover douser, and auditorium functions.

5. Hook up all wires as required in above instructions.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 57 58

Sem comentários

Christie CC70 Manual do Operador Página 17