Christie 38-RS1002-01 Manual do Operador descarregar pdf (Página 5)

Manufactured in the U.S.A by IDM Tech, LLC for CryoPen, Inc.

Distributed by CryoPen, Inc

CryoPen

- 5 -

Originated Date: 02.25.2010

Revision Date: 5.1.2012

OM-CT2-01-R6

DESCRIPTION:

The CryoPen

system provides a means of freezing tissue without the use of cryogenic gases or liquids. The system consists

of four pen cores, a refrigeration unit, re-usable tips in (4) four sizes and a temperature indicator. When used properly, the

system will deliver effective temperatures for tissue ablation.

The CryoPen

Cooling System: The unit is a refrigeration component that operates on AC 110-240 volts obtained from

conventional convenience outlets. It is used to lower the temperature of the CryoPen

pen cores to temperatures of

–105ºC to –110ºC.

The CryoPen

Pen Cores: Consists of a heat sink that has been shaped at one end to form a treatment surface that is inserted

into the pen tips. (4 sizes: 3mm, 5mm, 7mm and 10mm) A connection for proper temperature indication is on the top of the

pen core. Readiness of the Pen Cores should be checked using the temperature indicator for readiness before each use.

The CryoPen

Re-usable Tips: Tips consist of resilient medical grade plastic that contains an aluminum tip. When surgery is

complete, remove the pen core from the tip. Re-sterilize tips in-between patients. Failure to do this will result in non-sterile

conditions and may cause cross patient contamination.

Temperature Indicator: Indicates readiness of CryoPen

Pen Cores

To initialize, please ensure that the connector on the bottom of the indicator is fully seated on the pen core. If the status LED

fails to light, please try again.

When the temperature indicator is plugged into the CryoPen

Pen Core please allow between one/two seconds for the

indicator to register one of the following:

1. Solid red light indicates the CryoPen

is not cold enough for a procedure;

2. Blinking green light indicates that the CryoPen

has reached sufficient temperature to allow for a two minute

freeze time;

3. Solid green light indicates that the CryoPen

has reached optimal temperature to ensure a freeze time of three

minutes;

4. Blinking red /green lights together, indicates the CryoPen

is too cold to perform a procedure. Please contact

CryoPen

immediately in such an instance.

The temperature indicator’s status LED will stay lit for approximately three to five seconds while connected to a Pen

Core.

Note: The temperature indicator also turns solid red when connected to a pen core at ambient conditions. If no light

is visible when the indicator is attached to a pen core, contact CryoPen, Inc. at 1-877-246-3955

1 2 3 4 5 6 7 8 9 10 ... 13 14

Comentários a estes Manuais

Sem comentários

Christie 38-RS1002-01 Manual do Operador Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Projetores Christie 38-RS1002-01