
J Series 2.0, 2.4, and 3.0 kW Setup Guide A-1
020-100751-01 Rev. 1 (10-2011)
Appendix A: GPIO
This section explains how to use a GPIO link from the projector to external equipment, such as devices for
3D synchronizing.
A.1 GPIO Port
The GPIO connector located on the input panel provides a
flexible method of interfacing a wide range of external I/O
devices to the projector. There are 7 GPIO pins available on
the 9pin D-Sub GPIO connector, which are configurable via
RS-232 commands. The other two pins are reserved for
ground and power - see table below for pin identification.
Table A.1 GPIO Pin
GPIO PINS
PIN # SIGNAL
Pin 1 + 12V (200mA)
Pin 2 GPIO 2
Pin 3 GPIO 4
Pin 4 GPIO 6
Pin 5 Ground
Pin 6 GPIO 1
Pin 7 GPIO 3
Pin 8 GPIO 5
Pin 9 GPIO 7
The serial cable required for connecting the external device to the projector GPIO connector, must be
compatible with the external device.
Comentários a estes Manuais