Christie CC70HD Especificações descarregar pdf (Página 18)

Cube Installation and Setup

Entero HB Rear-Access Cube Installation and Setup Manual 18

020-101007-04 Rev. 1 (12-2014)

b. With the display cube enclosure resting on the lower level, adjust its alignment so the

side and rear edges between the two components are flush and the mounting holes are

aligned.

c. To secure the cube to the pedestal or cube in the lower level, use six M6 x 75 mm screws

(4 for CC50) with washers and hex nuts. To allow for small adjustments, do not fully

tighten the mounting hardware identified in step 1.

d. Use four M6 x 75 mm screws with washers and hex nuts

to attach the cube to the one adjacent to it. Hand

tighten the mounting hardware.

4. To minimize tension against the mirror at each adjustment

point, loosen each of the adjustment screws on the optical

mirrors.

5. Check the alignment between all of the display cubes and

make adjustments as required. All cubes must be aligned

vertically and horizontally.

6. Before installing another row of display cubes, tighten all

mounting hardware between the display cubes and pedestals.

Tighten hardware to a minimum torque setting of 11.1 Nm /

98 lbf–in.

7. To add the next row of cube enclosures, repeat steps 1 to 6.

• For a single, stand-alone unit, tighten the hardware until components are fully secured, then

proceed to Secure the cubes with tie backs on page 19.

Adjustment screws x10

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 56 57

Sem comentários

Christie CC70HD Especificações Página 18