
23
L2K1000 User Manual
020-000393-01 Rev.1 (04-2011)
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the
projector. Confirm the AC plug type with the chart below and proper AC power cord
must be used. If the supplied AC power cord does not match your AC outlet, contact
your sales dealer.
Projector side AC Outlet side
To POWER CORD
CONNECTOR on your
projector.
Ground
To the AC Outlet.
(120 V AC)
For Continental Europe
For the U.S.A. and Canada
To the AC Outlet.
(200–240 V AC)
This projector uses nominal input voltages of 100-240 V AC. It
is designed to work with single-phase power systems having a
grounded neutral conductor. To reduce the risk of electrical shock,
do not plug into any other type of power system.
If you are not sure of the type of power being supplied, consult
your authorized dealer or service center.
Connect the projector with all peripheral equipment before turning
on the projector.
CAUTION
The AC outlet must be near this equipment and must be easily
accessible.
Connecting the AC Power Cord
Installation
✔Note:
• Unplug the AC power cord or turn off the MAIN ON/OFF
Switch when the projector is not in use. When the projector is
in stand-by mode, it consumes a little electric power.
Connect the AC power cord (supplied) to the
projector.
Comentários a estes Manuais